agrounikwater treatmenttuv nord

Water treatment

Chlorine residual analyzer ah-2003

  • gas chlorination devices
  • dosing systems
  • automatic systems for chlorination and measurement devices
  • scada systems remote control and data transfer
  • production of sodium hypochlorite from salt
  • compact units for waste water treatment

AH-2003

AH-2003

Residual Analyzer Electronics

Residual Analyzer Electronics

Residual Analyzer Measuring Cell

Residual Analyzer Measuring Cell

Chlorine residual analyzer AH-2003 has been tested and proven as a reliable device for continuous and accurate measurement of the residual. The device works on the amperometric principle and it is designed to continuously measure free chlorine in the water, swimming pools or in various process applications. The measuring cell is equipped with built-in continuous electrode hydraulic cleaning system with rotating balls, which eliminates signal interference and need for frequent analyzer recalibration. Integrated two-point alarm (high and low residual) is standard. Sample is brought through the control valve which eliminates the need for special sampling pumps. Gold and copper electrodes of large areas are used to obtain maximum signal strength. The device is made of anti-corrosive materials. Each unit is pre-assembled, requiring only the connection of sampling lines.

Components and controls are available on the front panel enabling easy monitoring of the measured residual, sample flow rate, electrode cleaning system and adjustment of upper and lower alarm points.

Characteristics:

  • Continuous measurement
  • High reliability
  • High and low residual alarms
  • Automatic electrode cleaning system
  • Direct measurement of free chlorine
  • Independent adjustment of lower and upper limits

Accessories:

  • Pressure reducing valve
  • Ball Valve
  • Mechanical filter
  • Rotameter

Operating principle

Water sample, with unknown chlorine content, is brought into the measuring cell. Using the amperometric method, the measuring cell generates an electrical signal proportional to the chlorine content. This signal is converted by the transmitter into a current signal 4-20 mA. Measured value is displayed on integrated digital display on the front panel, as well as on optional remote pointers, printers etc. Residual chlorine concentration can be regulated in the preset limits (built-in relay contacts are turned on at particular, preset minimum and maximum chlorine level).

technical data:
Measuring range*: 0-1 mg/l Cl2
Sensitivity: 0.01 mg/l (ppm)
Linearity: 1%
Accuracy: 2%
Response time: cca 60sec
Sample flow: cca 500 ml/min
Sample connection: fleksibilno crevo, 06/1mm
Measuring method: amperometrički (Au/Cu)
Display: crveni LED, tri cifre
Power supply: 220V AC, 50Hz
Power consumption: <50mA
Analog output signal: 4-20mA
Current-loop impedance: 600Ω, max
Alarm Relay Contacts: 250V/2A, AC/DC
* On special request, measuring range can be different, up to 10mg/l

Comments are closed.